Comtech EF Data SDM-2020 - Manual (Page 36)

SDM-2020 Satellite Modulator Revision 7
Installation MN/SDM2020M.IOM
3-6
3.2.2.1 D
ATA
I
NTERFACE
R
EMOVAL
1 Disconnect power from the modulator.
2 Use a Phillips  screwdriver to loosen the two captive screws on the faceplate
of the data interface.
3 Grasp the data interface by the faceplate handle.
4 Carefully pull the data interface out of the slot.
3.2.2.2 D
ATA
I
NTERFACE
I
NSTALLATION
1 Disconnect power from the modulator.
2 Grasp the data interface by the faceplate handle.
3 Locate the opening at the rear of the modulator.
4 Carefully align the data interface with the card guides inside the modulator and
insert the data interface into the opening.
5 Push the data interface firmly into the slot, ensuring a good connection.
6 Align the captive screws located on the faceplate with the holes on the modulator
rear panel.
7 Use a Phillips  screwdriver to tighten the screws.