Comtech EF Data SLM-5650A - Manual (Page 197)

SLM-5650A Satellite Modem Revision 8
Network Processor (NP) Interface MN-SLM5650A
8–35
With Proxy ARP enabled, the NP Interface (in Router Mode) 'snoops' all ARP_REQs; it will
send an ARP_REPLY (one if the ARP_REQ host address is an NP host address that is reachable
via one of the routes in the Route Table).
Using the drop-down menu, set Proxy ARP Enable as Enabled or Disabled. Then, click
Submit] to save the desired Proxy ARP Enable setting.
8.6.6.4.2 LAN | Ethernet Ports
Use this page to view the current status of the Ethernet ports and to set each port to manual or
auto-negotiate configuration. Only the NP Interface Ethernet ports are shown in this screen. The
base modem Ethernet port statistics and port information are set from the modem’s front panel.
Figure 8-21. LAN | Ethernet Ports page
Ethernet Link Status
This read-only section displays the status for each NP Interface Ethernet port.
Ethernet Speed/Duplex
Use the drop-down menus to configure each port to one of the following states:
Auto 1000 Full 100 Full 10 Full 100 Half 10 Half
Click [Submit] once the Ethernet ports have been configured to suit on this page.