Comtech EF Data SLM-5650A - Manual (Page 195)

SLM-5650A Satellite Modem Revision 8
Network Processor (NP) Interface MN-SLM5650A
8–33
Item Description / Settings
Traffic Subnet Mask
This is the IP Address of the NP Interface only. Once set to a valid value, it is the address
that should be used for management and control connectivity as well as the Next Hop
Address for other routers in the user’s network based on IP Addressing mode.
Traffic Subnet Mask The Subnet Mask is used in conjunction with the Traffic IP Address to determine the
subnet locally attached to by the LAN interfaces.
Management IP
Address
This is the IP Address of the NP Interface only. Once set to a valid value, it is the address
that should be used for management and control connectivity when IP Addressing Mode
was set to Dual.
Management
Subnet Mask
The subnet mask is used in conjunction with the Management IP Address to determine
the subnet locally attached to by the LAN interfaces.
Click [Submit] to save changes made to any of the above items.
VLAN Port Configuration
Item / Selection Description / Settings
Single Port VLAN
Using the drop-down menu, select Single Port as Enabled or Disabled. When Single
Port VLAN is Enabled, the SLM-5650A’s Ethernet port accepts the VLAN-tagged
packets from the NP Interface port specified in the "VLAN Port Select" drop-down.
VLAN Port Select
Using the drop-down menu, select Port 1 through Port 4 to designate the Ethernet port
on which VLAN-tagged packet are ingress and egress.
VLAN ID
Enter an ID value from 2 to 4095. Packets containing specified VLAN only will ingress
and egress from the NP Interface port specified in the "VLAN Port Select" drop-down.
Click [Submit] to save the desired Single Port VLAN setting.
When BPM Mode is enabled and any Vipersat
operating mode other than Vipersat Hub or
Vipersat Hub Expansion is selected (see Chapter
Sect. 8.6.6.2.1), the VLAN Port Configuration
portion of the ‘LAN | Interface’ page becomes
disabled and is not visible, as shown to the right:
However, when BPM Mode is enabled and either
Vipersat Hub or Vipersat Hub Expansion is
selected (see Chapter Sect. 8.6.6.2.1), the VLAN
Port Configuration portion of the ‘LAN | Interface’
page is replaced with the Multi-TDM Tunneling
Mode controls, as shown to the right: