Comtech EF Data SLM-5650A - Manual (Page 178)

SLM-5650A Satellite Modem Revision 8
Network Processor (NP) Interface MN-SLM5650A
8–16
8.6.6.2.4 Admin | SNMP
The Admin user may use this page to change the parameters associated with Simple Network
Management Protocol, an application-layer protocol designed to facilitate the exchange of
management information between network devices. The SLM-5650A SNMP agent supports
SNMPv1, SNMP v2c, and SNMP v3. See Chapter 6.4 SNMP Interface for complete details on
SNMP and using this page.
Figure 8-9. Admin | SNMP page
SNMP
SNMP Read Community and SNMP Write Community cannot be changed; the default for Read
Community default is public; the Write Community default is private.
Click [Submit] to enable the SNMP configuration changes made to Trap Community, Trap,
System Contact, and System Location.
SNMP v3
This section is used to create user accounts under SNMPv3 protocol. SNMPv3 is available only
when the IP Interface Security Mode security level setting is set to “High”.
Using the provided text boxes, create an Engine ID (the default is 0000000c000000007f000001),
User Name and Password as needed (the default for both is comtech) then, using the available
drop-down menu, select the Security Model algorithm as md5 or sha. Note that this setting must
match the setting in the SNMP client, or the SLM-5650A will not allow communications.
Click [Submit] to enable the SNMP v3 configuration changes made in this section.