Comtech EF Data SLM-5650A - Manual (Page 114)

SLM-5650A Satellite Modem Revision 8
Front Panel Operation MN-SLM5650A
5–32
To edit the Gigabit Ethernet Interface’s Management IP Address and Range, first use the 
arrow keys to select the digit to edit, and then use the  arrow keys to edit the value of that
digit. Press [ENT] when done.
CONFIG: Remote  EthernetConfig  Option Card Addr  Network
Proc
NP Card: AddrMode:Dual Security: Low
BPM:Off Traffic IP Mgmt IP (E)
Use the  arrow keys to select AddrMode, Security, BPM, Traffic IP, or Mgmt IP , and
then press [ENT].
CONFIG: Remote  EthernetConfig  Option Card Addr  Network
Proc  AddrMode
Use the  arrow keys to select the Address Mode as Local or Dual, and then press [ENT].
When in Single Address Mode, select Traffic IP to edit the NP Module’s
Ethernet IP Address and Range.
When in Dual Address Mode, select Mgmt IP to edit the NP Module’s Ethernet
IP Address and Range.
CONFIG: Remote  EthernetConfig  Option Card Addr  Network
Proc  Security
Use the  arrow keys to select the FAST-enabled Management Security level as Low or
High, and then press [ENT].
CONFIG: Remote  EthernetConfig  Option Card Addr  Network
Proc  BPM
Use the  arrow keys to select the FAST-enabled BPM mode as On or Off, and then
press [ENT].