Comtech EF Data SLM-5650A - Manual (Page 113)

SLM-5650A Satellite Modem Revision 8
Front Panel Operation MN-SLM5650A
5–31
CONFIG: IP  EthernetConfig  SNMP  Traps  Address #1/#2
SNMP Traps IP Address #X:
000.000.000.000 (E)
Where X indicates IP Address #1 or IP Address #2: To edit the SNMP Trap Destination IP
Address, first use the

arrow keys to select the digit to edit, and then use the  arrow
keys to edit the value of that digit. Press [ENT] when done.
Note: If both Trap IP Addresses are 000.000.000.000, it means that Trap is disabled.
CONFIG: IP  EthernetConfig  SNMP  Traps  Community
SNMP Trap Community:
comtech (E)
To edit the SNMP Trap Community string, first use the

arrow keys to select the
character to edit, and then use the arrow keys to edit that character.
Note: Only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash ‘/’ (ASCII
code 92) and tilde ‘~’ (ASCII code 126).
Once the string has been composed, press [ENT]. All trailing spaces are removed from the
Trap Community string upon entry.
CONFIG: IP  EthernetConfig  SNMP  Traps  Version
SNMP Version: SNMPv1 SNMPv2
(E)
Select SNMPv1 or SNMPv2 using the

arrow keys, and then press [ENT].
CONFIG: Remote  EthernetConfig  Option Card Addr
Option Card Addr: Gigabit Ethernet
Network Proc
Select Gigabit Ethernet or Network Proc using the

arrow keys, and then press [ENT].
CONFIG: Remote  EthernetConfig  Option Card Addr  Gigabit
Ethernet
Option Card Ethernet IP Address/Range:
192.168.001.002/24 (E)