Comtech EF Data SLM-5650A - Manual (Page 106)

SLM-5650A Satellite Modem Revision 8
Front Panel Operation MN-SLM5650A
5–24
Setting Valid Operational Range
Nominal: Nominal Output Power: : -40 to +10 dB.
Min: Minimum Output Power: -40 to +10 dB.
Max: Maximum Output Power: -40 to +10 dB.
CONFIG: AUPC  Local  Target Settings
Target Settings: Eb/No: 0.60 dB
RateOfChange: 1.0 dB/Minute (E)
First, use thearrow keys to select Eb/No or RateOfChange, and then press [ENT].
Then, for either selection, use thearrow keys to first select the digit to edit, and then use
the  arrow keys to edit the value of that digit. Press [ENT] once again when done.
Setting Valid Operational Range
Eb/No To set the Target Eb/No for AUPC: 3.2–16.0 dB.
RateOfChange To set the maximum tracking rate: 0.5–6.0 dB per minute (in 0.5 dB increments)
CONFIG: AUPC  Local  Carrier Loss Action
Carrier Loss: Local: HOLD
Remote: HOLD (E)
First, use thearrow keys to select Local or Remote, and then press [ENT]. Then, for
either selection, use the  arrow keys to select HOLD, NOMINAL, or MAXIMUM.
Option Function
Local Sets the action of the local modem when it loses carrier detect.
Remote Sets the action of the local modem when the remote modem loses carrier detect.
CONFIG: AUPC  Remote
Remote AUPC: Enable: Off BasebandL: Off
Tx Pattern: Off BER: Loss (E)
First, use the arrow keys to select Enable, BasebandL, Tx Pattern, or BER, and then press
[ENT]. Then, typical for all selections, use the  arrow keys to select operation as On or Off.
Option Function
Enable View or modify the status of the remote modem’s AUPC Enable.