Comtech EF Data SLM-5650A - Manual (Page 111)

SLM-5650A Satellite Modem Revision 8
Front Panel Operation MN-SLM5650A
5–29
CONFIG: Remote  SerialConfig  Format
Local M&C Bus Format: 8N1
(E)
Use the  arrow keys to select the character format 7N1, 7E1, 7O1, 7N2, 7E2, 7O2, 8N1
(default), 8E1, 8O1, 8N2, 8E2, or 8O2, and then press [ENT].
CONFIG: Remote  SerialConfig  Baudrate
Local M&C Bus Baud Rate:
38400 Baud (E)
Use the  arrow keys to select a Baud Rate of 2400, 4800, 9600, 19200, 38400 (default),
57600, or 115200, and then press [ENT].
CONFIG: Remote  EthernetConfig
Ethernet Config: IP Address/Range MAC
Gateway SNMP Option Card Addr (E)
Use the arrow keys to select IP Address/Range, MAC, Gateway, SNMP, or Option Card
Addr, and then press [ENT].
Option Function
IP Address/Range Select the IP Address.
MAC
Displays the modem’s MAC Address: This is programmed at the factory and is not user
changeable. If installed, the Gigabit Ethernet Interface’s MAC Address will also be
displayed.
Gateway
The IP Gateway Address is the default address that the modem will send all IP responses
when the message originated from a source outside the modems local attached network.
SNMP Select and control Communities or Traps. Detailed information follows.
Option Card Addr
Select to set the optional Gigabit Ethernet or Network Processor Module’s Ethernet
interface IP Address and subnet mask (range). When Network Proc is selected, module
configuration options are also available. (Detailed information for configuring either option
card follows.)
CONFIG: Remote  EthernetConfig  SNMP
SNMP: Communities Traps
(E)
Use the arrow keys to select Communities or Traps, and then press [ENT].