Comtech EF Data SLM-5650A - Manual (Page 108)

SLM-5650A Satellite Modem Revision 8
Front Panel Operation MN-SLM5650A
5–26
Option Settings
Clear-All
Use the arrow keys to select No or Yes to clear all stored AUPC statistics, and then
press [ENT].
Config
Use the  arrow keys to set the interval that the statistics are stored, and then press
[ENT]. Valid selections are 10 minutes through 90 minutes (in 10-minute increments), or
Disabled.
5.2.3.5 CONFIG: Transec
TRANSEC: State: Encrypted
Module IP Address Gateway (E)
Use the arrow keys to select State, Module IP Address, or Gateway, and then press [ENT].
Option Settings
State Select Encrypted or Bypass.
Module IP
Address
Set the TRANSEC Module’s Management IP Address and subnet mask length.
Gateway Set the TRANSEC Module’s IP Gateway.
5.2.3.6 CONFIG: AntHndOvr
AntHndOvr: Mode: Off State: ONLINE
PwrOffset: +01.2 Delay: 040ms (E)
Use the arrow keys to select Mode, State, PwrOffset, or Delay, and then press [ENT].
Setting Function
Mode Select the Antenna Handover Mode as Off, Man, or Auto.
State Select the current modem state as ONLINE or OFFLINE.
PwrOffset Select the offset that is added to the Tx power level to compensate for system loss.
Delay Select the size of the buffer used during Handover events.
5.2.3.7 CONFIG: Ref
Reference: Internal Ext-1Mhz
Ext-5Mhz Ext-10Mhz (E)
Use the arrow keys to select Internal, Ext-1Mhz, Ext-5Mhz or Ext-1Mhz, and then press
[ENT].