Avery Dennison Sierra Sport2 9460 Programmer Manual User Manual
Page 29
B5. supply_posn Supply Position. Range: -99 to 99 in 1/203 inch. 0 is the default. Adjusts
the machine to print at the vertical 0,0 point on the supply. This adjustment
accounts for mechanical tolerances from machine to machine. The supply
position adjustment only needs to be made on the initial machine setup.
Adjust the supply position if formats do not start at the 0,0 point on the
supply. Increase the supply position to move print up, decrease to move
print down on the label. To verify the 0,0 point, print a test label. See
“Printing a Test Label” in Chapter 8 for more information.
You can not change the supply position while the printer is active.
Changing the supply position will affect the print position, dispense
position, and backfeed distance. Once the supply position is set, use the
print control packet and backfeed control packet to adjust printing and the
dispense position.
Example
{
I,B,0,0,1,10 p }
Indicates black mark and thermal direct stock has been loaded, causes the
printer to operate in on-demand mode (purchase optional), and feeds the
supply approximately .05 inches up before printing the format on each label
(10/203 inches).
Configuring the Printer 2-11