Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 148)

575 The graphic included in your format could not be found. Resend
the graphic packet. If the error persists, call Technical Support.
600 The printer could not image the batch, because the batch was
refused. Call Technical Support.
601 An error occurred while the batch was imaging. Resend the
format, batch, font, and/or any graphic packets. If the error
persists, call Technical Support.
603 The batch was not found while imaging. Resend the batch packet.
If the error persists, call Technical Support.
611 Font, bar code or density is invalid. The font, bar code or density
in the batch does not fit the format.
612 The data in this line of the batch is either missing or does not
match the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid character in the
packet. Make sure you did not enter O for Ø.
615 Bar code width is greater than 16 inches or the number of
keywords for your PDF 417 bar code exceeds 928. Decrease the
density or shorten the amount of data to print the bar code.
616 A bad dot falls on a bar code and the dot cannot be shifted. A
gray box is printed instead of the bar code.
618 Magnification must be 1 to 7 or 4 to 255 (point size) for the
scalable font.
619 The JIS (16-bit) code for Kanji is invalid.
620 Font and printhead dot density mismatch. A 300 dpi font is
specified in the format, but a 203 dpi printhead is used in the
printer or vice-versa. Check the font or change the printhead to
correct the error. Only valid for printers with a 300 dpi printhead.
621 An error occurred opening the TrueType font file. Select a
different font to download. If the error message persists, call
Technical Support.
8-16 Diagnostics and Errors