Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 23)

U s i n g O n l i n e C o n f i g u r a t i o n P a c k e t s
Use online configuration packets to change the printer’s settings. You can
send an individual configuration packet or a single packet containing all the
configuration packets. Supply all parameters for each packet. Leave the
parameters blank that you do not need to change. For example,
{ I ,A,,,,1 p }
prints a slashed zero and uses the last sent online System Setup
parameters.
Make a copy of the online configuration worksheet in Appendix D, “Format
Design Tools,” and save the original. Packets A-M are listed on the
worksheet.
When you turn off the printer, all the information in the online configuration
packets is saved and used when the printer is turned back on. After you
change printer configurations, you must resend the format, batch, or graphic
to the printer before the changes take effect.
Always include an I , im me di ately af ter the left bracket { and be fore the
packet iden ti fier (A, B, C, etc.). The I pa ram e ter iden ti fies the data stream
as a con fig u ra tion packet.
Note: Include the I pa ram e ter with each packet if you are send ing them
in di vid u ally. In clude it only at the be gin ning of a data stream if you
are send ing mul ti ple pack ets.
Configuring the Printer 2-5