Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 129)

Status2
D- Parameter represents the parameter within the field that the error
occurred. The numbering begins after the field
identifier.
Status2
E- Error Number is the error that coincides with the error numbers
presented in Chapter 8, “Diagnostics and Errors.”
“FMT-1/BCH-2" The format or batch number is returned.
Note: If more than one error occurred, only the most serious error is
acknowledged.
{J,"","F,B,4,6,33","FMT-1","BCH-2"}
Indicates that an error occurred on a bar code (B) field within a format (F)
packet. The bar code field is the fourth (4) field in the packet. The error
occurred in the sixth (6) parameter of the field. Error number 33 means the
bar code density is invalid.
To clear an error, press the left A button. An ENQ can also clear errors
numbered less than 500. Once the error is corrected, a job request can be
sent. The printer cannot accept another job request until the error is
resolved.
The following syntax is the response for a Job 4 request.
Syntax
{J,printed,total,"FMT-1","BCH-2"}
printed the number of tags or labels already printed in the
batch.
total the total number of tags or labels to be printed in the
current batch.
“FMT-1/BCH-2" The format or batch number is returned.
Example
{J,8,25,"FMT-3","Bch-2"}
8 out of 25 tags or labels have been printed from format number 3.
Use a Job Request 4 when printing in the on-demand mode with a large
number of tags or labels from a single batch. A Job Request 4 may not be
accurate if tags or labels are printed in continuous mode, because of the
response time involved. A Job Request 4 is not useful in single ticket
batches (printing 1 of 1) or multiple single ticket batches.
Status Polling 7-11