Avery Dennison Sierra Sport2 9460 Programmer Manual User Manual
Page 151
766
Backfeed error. There is a problem with the backfeed or overfeed
distance.
767
Incorrect AD value. Call Technical Support.
768
Printhead has more than 10 bad dots within the format area or is
not connected. Make sure the printhead is connected.
769
The printhead is not receiving enough volts. Call Technical
Support.
770
The print motor is not ready. Call Technical Support.
771
The format specified by the application was not found. Reload
your application and format, and try again. If the problem
continues, call Technical Support.
781
The voltage is too low. Call Technical Support.
782
The voltage is too high. Call Technical Support.
790
The printer is busy. Wait until the printer is idle (no batch waiting
to print or not receiving data) before you send any packets. This
error may occur when you try to print a test label if the printer is
busy. Turn off the printer. Wait two seconds and turn it back on.
Resend the packets. If the problem continues, call Technical
Support.
791
The printer has an error pending. Turn off the printer. Wait 15
seconds and turn it back on. Resend the packets. If the problem
continues, call Technical Support.
792
The printer is not initialized. Call Technical Support.
793
The printer job queue is full. Turn off the printer. Wait 15
seconds and turn it back on. Resend the packets. If the problem
continues, call Technical Support.
794
The backfeed mode is not set.
795
Print engine lock-up. Call Technical Support.
Diagnostics and Errors 8-19