Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 146)

411 Framing error. The printer cannot communicate with the host.
Make sure the host is turned on, communication cables are
connected correctly, port settings are correct, and
communications are active. Check the baud rate, word length,
and stop bits to make sure they match those at the host. Do not
toggle between Microsoftâ Windowsâ and MS-DOS while using
the COPY command, or you will receive a framing error. Exit
Windows before using the COPY command. Re-transmit the
data.
412 There is a problem with flow control between the printer and the
host. Make sure the printer and the host flow control settings
match (both are DTR or both are XON/XOFF). If the error
persists, call Technical Support.
413 Online receive buffer is full. Check your printer’s XON/XOFF or
DTR SETUP values to be sure there is not a flow control problem.
414 The internal keyboard buffer is full or you need a new keypad.
Call Technical Support.
415 The buffer size you defined exceeds the total available in your
machine.
420 Internal software list error. Call Technical Support.
421 Internal software list error. Call Technical Support.
422 Duplicate internal name. Call Technical Support.
423 Internal software error. Call Technical Support.
424 Internal software list error. Call Technical Support.
425 Internal software list error. Call Technical Support.
426 Internal software list error. Call Technical Support.
427 Format name is invalid. Valid name is 1 to 8 characters inside
quotes or “” for a printer-assigned name. Press the left A button
and try to continue. If the error reappears, call Technical Support.
8-14 Diagnostics and Errors