Sample 2-6, Configuration upload 2-6 - 2-7, Packet sample 2-6 – Avery Dennison Sierra Sport2 9460 Programmer Manual User Manual
Page 24: Upload syntax 2-6 - 2-7, Configuration packet 2-6, Printer configuration upload 2-6 - 2-7, Configuration 2-6 - 2-7
This is the syntax to use when you create online configuration packets:
Syntax
{
Start of Header
I,
Con fig u ra tion Header
1 - 8 op
tional re
cords
A, pa ram e ter 1...pa ram e ter 5
p
Sys tem Setup
B, pa ram e ter 1...pa ram e ter 5
p
Sup ply Setup
C, pa ram e ter 1...pa ram e ter 5
p
Print Con trol
D, pa ram e ter 1...pa ram e ter 3
p
Mon e tary For mat ting
E, pa ram e ter 1...pa ram e ter 9
p
Con trol Char ac ters
F, pa ram e ter 1...pa ram e ter 5
p
Com mu ni ca tion Set tings
G, pa ram e ter 1...pa ram e ter 4
p
Backfeed Con trol
M, pa ram e ter 1...pa ram e ter 4
p
Mem ory Con fig u ra tion
}
End of Header
Syntax for single packet
{
Start of Header
I,
Con fig u ra tion Header
A, pa ram e ter 1...pa ram e ter 5
Sys tem Setup
}
End of Header
You can also add a configuration to RAM or specify units for supply, print,
margin, and cut positions. If you use the optional parameters with the
I
packet, any online configuration packets following the split vertical bar
( p )
must specify distances using the selected units. However, the test labels
display the units in dots, even if you entered them in English or Metrics
units.
Syntax
{header,ID#,action,device
p }
1. header
Constant
I.
2. ID#
ID. Use 0.
3. action
Action. Options:
A
Add configuration.
U
Upload User Configuration.
4. device
Storage Device. Use R (Volatile RAM).
2-6 Configuring the Printer