Defining the supply setup packet 2-10, Supply setup packet b 2-10, Truetype 2-10, b-1, b-9, b-12, c-2 – Avery Dennison Sierra Sport2 9460 Programmer Manual User Manual
Page 28: Syntax 2-10, Ribbon selection 2-10, Feed mode 2-10, Ribbon 2-10, Supply type/position 2-10, Type/position selection 2-10, Truetype font 2-10, b-1, b-9, b-12, c-2
Note:
The Standard, Reduced, Bold, OCRA and HR fonts only support
the Internal Symbol Set (0). The CG Triumvirate™ typefaces
support only the ANSI and DOS Code Page 437 and 850 Symbol
Sets. The scalable font (font 50) does not support Code Page
1256 (Arabic). Code pages 852-860 and 1250-1258 are for
downloaded TrueType® fonts or the scalable font. Symbol set 19
requires a downloaded International TrueType font. TrueType
fonts are designed to be regionally specific; therefore, all code
pages may not be supported in a given font. See Appendix C for
more information.
Example
{
I,A,0,0,0,1,0 p }
Powers up the printer in the online mode, displays prompts in English, does
not print a separator after each batch, prints zeros with slashes through
them, and uses the internal symbol set.
D e f i n i n g t h e S u p p l y S e t u p P a c k e t
Use the supply setup packet (B) to select supply type, printhead energy,
feed mode, and supply position.
Syntax
{
I,B,sup ply_type,ph_en ergy,feed_mode,sup ply_posn p}
B1. B
Supply Setup Packet
B2. supply_type
Supply Type. Options:
0
Black mark supply
1
Die Cut/edge aperture supply (default)
2
Continuous (non-indexed) supply
Note:
You must use continuous (non-indexed) supply in continuous mode
You may need to adjust the print contrast (in the Print Control
packet) based on the type of supply you are using.
B3. ph_energy
Printhead energy. Options:
0
Standard Supplies (default)
1
Special (fax paper)
2
High Energy (linerless and synthetic)
Note:
We do not recommend printing serial bar codes with linerless
supplies.
B4. feed_mode
Feed Mode. Options:
0
Continuous operation (default)
1
On-demand mode (purchase optional)
2-10 Configuring the Printer