Configuration syntax guidelines 2-8, Making print adjustments 2-8, Adjustments, print 2-8 – Avery Dennison Sierra Sport2 9460 Programmer Manual User Manual
Page 26: Guidelines 2-8, Print adjustments 2-8, Packet guidelines 2-8, Horiz adjustment 2-8, Vert adjustment 2-8, Configuration syntax guidelines -8, Making print adjustments -8
The parameters for each packet (A-M) are displayed. The remaining lines
beginning with M list the buffer sizes in 1/10K for the Receive, Transmit,
Image, Downloadable Fonts, Formats, and Scalable Fonts Buffers.
C o n f i g u r a t i o n S y n t a x G u i d e l i n e s
When creating a printer configuration packet:
¨ Follow the “Standard Syntax Guidelines” listed at the beginning of this
chapter.
¨ The first character after the start of header ({) is the configuration
header (
I
).
¨ Download multiple configuration packets within one packet or download
a single configuration packet.
¨ If you change any of the online configuration packets, resend the format
packet to the printer, so the configuration changes take effect.
¨ Include the first five ANSI codes, at a minimum, in the control characters
packet.
¨ Send configuration packets once per session (each time the printer is
turned off and then back on), not with every format or batch packet.
¨ Make sure the communication settings at the host match those at the
printer.
M a k i n g P r i n t A d j u s t m e n t s
You can adjust where the printer prints on your supply by adjusting the
supply, print, or margin positions. However, keep in mind the following:
¨ Supply adjustments across the width of your supply, such as the margin
position, are based in dots. The printhead has 203 dots per inch.
¨ Supply adjustments for the length of your supply, such as supply position
or print adjustment, are measured in 1/203 of an inch.
2-8 Configuring the Printer