Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 185)

S Y M B O L S E T S / C O D E P A G E S
C
This appendix contains a listing of the symbol sets, code pages,
and extended character sets the printer supports.
Use the charts in this appendix to convert dot sequences from the
image dot pattern to codes you can use in the fields. Use the
Binary to Hex Conversion Chart to convert Binary dot sequences to
Hexadecimal numbers for bitmap files. Use the Dot to Run Length
Encoding Chart to convert dot sequences to alphabetic characters
for bitmap files.
S u p p o r t e d S y m b o l S e t s a n d C o d e P a g e s
The printers support these symbol sets and code pages: Internal,
ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850.
Additional Code Pages are supported with downloaded TrueType
or Unicode (double-byte) fonts.
The printer defaults to the internal symbol set. See “Defining the
System Setup Packet” in Chapter 2 to change the symbol set.
S e l e c t i n g a S y m b o l S e t o r C o d e P a g e
The CG Triumvirate™ typefaces support only the ANSI and DOS Code Page
437 and 850 Symbol Sets. These fonts print a slashed zero when using the
ANSI symbol set.
Internal Use this symbol set to print international monetary
symbols, the trademark (™) symbol, and for formats that
may be used on other MPCLII printers.
ANSI Use this symbol set with proportionally spaced
fonts.
DOS Code
Pages 437 or 850 Use this symbol set for extended and international
characters with proportionally spaced fonts.
Symbol Sets/Code Pages C-1