Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 97)

BIOS
ATCA-7365 Installation and Use (6806800K65M) 97
4.4 Boot Options
This section describes which boot devices are supported by the BIOS and how to select the
boot device.
4.4.1 Supported Boot Devices
The BIOS supports booting from the following devices/sources:
 USB devices, such as floppy, CD ROM and hard disk
 Solid State Disk connected to the SATA interface. (available only when SSD SATA is
assembled)
 Storage devices connected to the SAS controller (by RTM)
 Network (Front Panel Ethernet, Base Ethernet and Ethernet on RTM)
 Storage devices connected to the Fiber Channel module (by RTM)
 iSCSI block devices connected to Base or Fabric Ethernet
4.4.2 Selecting The Boot Device
There are two possibilities to determine the device from which BIOS attempts to boot:
 By setup to select a permanent order of boot devices
 By boot selection menu to select any device for the next boot-up procedure only