Artesyn ATCA-7365 Installation and Use (May 2014) User Manual

Page 66

Hardware Preparation and Installation

ATCA-7365 Installation and Use (6806800K65M)

Installation Procedure

The following procedure describes the installation of the blade. It assumes that your system is
powered on. If your system is not powered on, you can disregard the blue LED and skip the
respective step. In this case, it is purely a mechanical installation.

1. Ensure that the top and bottom ejector handles are in the outward position by

squeezing the lever and the latch together.

2. Insert blade into the shelf by placing the top and bottom edges of the blade in the

card guides of the shelf. Ensure that the guiding module of shelf and blade are
aligned properly.

3. Apply equal and steady pressure to the blade to carefully slide the blade into the

shelf until you feel resistance. Continue to gently push the blade until the blade
connectors engage.

4. Squeeze the lever and the latch together and hook the lower and the upper handle

into the shelf rail recesses.

This manual is related to the following products:

ATCA-7360 Installation and Use (May 2014) ATCA-7360 Installation and Use (February 2015) ATCA-7365-CE Installation and Use (Jan 2015) ATCA-7365 Installation and Use (November 2014)