Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 242)

Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65M) 242
sata1 SATA device 1 (RTM Debug SATA)
sata5 SATA device 5 (Onboard SATA)
sataonboard SATA device 5 (Onboard SATA)
sashdd SAS HDD mounted on the RTM
sas0_nn SAS Controller nn = SCSI ID
(use this when a SAS array is connected to the RTM)
frontnet Front Panel Network
basenet0 Base Ethernet Interface Channel 1
basenet1 Base Ethernet Interface Channel 2
fabricnet0 Fabric Ethernet Interface Channel 1
fabricnet1 Fabric Ethernet Interface Channel 2
usb1 USB frontpanel 1
usb2 USB frontpanel 2
usbonboard USB onboard HDD
usbartm USB artm
usbkey USB key
usbcdrom USB cdrom
usbhdd USB hdd
usbfdd USB floppy disk
efishell Built in UEFI shell
uefi# UEFI Media path place holder which points to the
corresponding uefi# parameter
Up to 10 boot devices are supported.
Example: boot_order=sas0_03,basenet0,usbkey,sata1
Note: uefi network devices are only available when Network Stack in Advanced
Setup Menu is set to enabled.
Table 8-16 boot_order Devices (continued)
Device Description