Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 62)

Hardware Preparation and Installation
ATCA-7365 Installation and Use (6806800K65M) 62
Installation Procedure
To install a PMEM/SATA module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 64 .
2. Plug the PMEM/SATA module on the blade so that the module's standoffs fit in the
blade's mounting holes.
3. Fasten the PMEM/SATA module to the blade using the two screws that previously had
fixed the S/F memory module to the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 64 .
The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.