Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 249)

Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65M) 249
8.4 Pigeon Point Specific Commands
The IPMC supports additional IPMI commands that are specific to Pigeon Point. This section
provides detailed descriptions of those extensions:
Table 8-24 Pigeon Point Extension Commands
Command
NetFn
(Request/Response)
CMD
Get Status Table 8-26 on page 250 0x2E/0x2F 0x00
Get Serial Interface Properties Table 8-27 on page 253 0x2E/0x2F 0x01
Set Serial Interface Properties Table 8-28 on page 254 0x2E/0x2F 0x02
Get Debug Level Table 8-29 on page 255 0x2E/0x2F 0x03
Set Debug Level Table 8-30 on page 256 0x2E/0x2F 0x04
Get Hardware Address Table 8-31 on page 257 0x2E/0x2F 0x05
Set Hardware Address Table 8-32 on page 257 0x2E/0x2F 0x06
Get Handle Switch Table 8-33 on page 258 0x2E/0x2F 0x07
Set Handle Switch Table 8-34 on page 259 0x2E/0x2F 0x08
Get Payload Communication Time-Out Table 8-35 on page
259
0x2E/0x2F 0x09
Set Payload Communication Time-Out Table 8-36 on page
260
0x2E/0x2F 0x0A
Enable Payload Control Table 8-37 on page 261 0x2E/0x2F 0x0B
Disable Payload Control Table 8-38 on page 261 0x2E/0x2F 0x0C
Reset IPMC Table 8-39 on page 262 0x2E/0x2F 0x0D
Hang IPMC Table 8-40 on page 262 0x2E/0x2F 0x0E
Graceful Reset Table 8-41 on page 263 0x2E/0x2F 0x11
Get Payload Shutdown Time-Out Table 8-42 on page 264 0x2E/0x2F 0x15
Set Payload Shutdown Time-Out Table 8-43 on page 265 0x2E/0x2F 0x16
Get Module State Table 8-44 on page 265 0x2E/0x2F 0x27
Enable Module Site Table 8-45 on page 267 0x2E/0x2F 0x28
Disable Module Site Table 8-46 on page 267 0x2E/0x2F 0x29