Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 81)

Controls, Indicators, and Connectors
ATCA-7365 Installation and Use (6806800K65M) 81
3.3 On-board Connectors
The blade provides the following on-board connectors:
 PMEM/SATA module connector
 USB flash module connector
3.3.1 PMEM/SFMEM Module Connector
The PMEM/SFMEM Module connects to the blade through a connector that carries the
following types of signals:
 PCI interface signals
 I2C signals for connection with on-board IDROM device
 Four configuration pins used for memory configuration
 1 SATA port connection (ICH10 port #5)
 Power supply 5V and 3.3V
Table 3-3 Face Plate VGA Connector Signals
Pin Signal Pin Signal Pin Signal
11 - 6 GND 1 RED
12 SDA 7 GND 2 GREEN
13 HSYNC 8 GND 3 BLUE
14 VSYNC 9 +5V 4 -
15 SCLK 10 GND 5 GND
Ensure that the display devices that are permanently connected to the VGA interface
provide a fire enclosure according to the IEC/EN/UL/CSA 60950-1 requirements.
All other devices that are connected only for service purposes to the VGA interface needs
supervision during operation and must be disconnected after maintenance.