Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 118)

BIOS
ATCA-7365 Installation and Use (6806800K65M) 118
4.5.5 Boot
Target Name Enter the target name. Not available when DHCP is
enabled.
Target IP Address 0.0.0.0 IP address of the target device. Not available when DHCP
is enabled.
Target Port 0 Target Port. Not available when DHCP is enabled.
Boot LUN 0 Hexadecimal representation of the LUNumber. Examples
are: 4752-3A4F-6b7e-2F99, 6734-9-156f-127, 4186-9.
Not available when DHCP is enabled.
CHAP Type None (Default),
One Way,
Mutual Select the CHAP (Challenge-Handshake Authentication
Protocol) type.
Save Changes Press Enter to save changes.
Back To Previous Page Press Enter to return to the previous page (same as ESC)
Table 4-24 iSCSI (continued)
Item Values Description
Table 4-25 Boot
Item Values Description
Setup Prompt Timeout 0..65535 seconds
Default 2 seconds Number of seconds to wait for setup activation key.
65535(0xFFFF) means indefinite waiting.
Bootup NumLock State On/off
Default on Select the keyboard NumLock state.
Interrupt 19 Capture Enable,
Disable (Default) If enabled, allows Option ROMs to trap Int 19. This is
needed e.g. for some SCSI/SAS controller.
Boot Option Priorities Select the boot device order.