Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 117)

BIOS
ATCA-7365 Installation and Use (6806800K65M) 117
4.5.3.2 IPMI -> System Event Log
4.5.4 iSCSI
This menu is for configuration of iSCSI boot of UEFI compatible operating systems. iSCSI boot
is enabled when UEFI Network stack is set to "Enabled" (see
Advanced -> UEFI Network Stack on
page 113 ).
For every network device, there is a submenu for configuration of iSCSI boot.
Table 4-23 IPMI -> System Event Log
Item Values Description
Log EFI Status Codes Disabled,
Both (Default),
Error code, Progress code Configure the logging of EFI Status Codes to IPMI
Firmware Progress/Error events and other Status/Error
IPMI events. See
IPMI Error Logging on page 129
Table 4-24 iSCSI
Item Values Description
iSCSI Initator Name The worldwide unique name of the initiator. Only IQN
(iSCSI Qualified Name) format is accepted.
Enable iSCSI Enable,
Disable (Default) Enable/Disable iSCSI for this Ethernet Port.
Enable DHCP Enable,
Disable (Default) Enable/Disable DHCP to retrive IP address, Subnet Mask,
Gateway…
Initator IP Address 0.0.0.0 IP address of the initator. Not available when DHCP is
enabled.
Initiator Subnet Mask 0.0.0.0 Subnet Mask for the Initiator Network. Not available
when DHCP is enabled.
Gateway Enter IP address of Gateway. Not available when DHCP is
enabled.
Get target info via DHCP Enable,
Disable (Default) Get target info via DHCP.