Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 64)

Hardware Preparation and Installation
ATCA-7365 Installation and Use (6806800K65M) 64
The location of the USB 2.0 Flash Module is shown in Figure "ATCA-7365 Blade Layout (Variants
with ten DIMM sockets)" on page 54 .
Removal Procedure
To remove a USB flash module, proceed as follows:
1. Remove blade from system as described in Removing the Blade on page 68 .
2. Remove the screw on the left side of the flash module (see figure Figure 2-2 on
page 54 ).
3. Lift the flash module from the socket.
Installation Procedure
To install a USB flash module, proceed as follows:
1. Remove blade from system as described in Removing the Blade on page 68 .
2. Insert new flash module in socket (see figure Figure 2-2 on page 54 ).
3. Tighten the screw on the left side of the flash module.
2.6 Installing and Removing the Blade
The blade is fully compatible to the AdvancedTCA standard and is designed to be used in
AdvancedTCA shelves.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.