Firmware upgrade, 1 hpm.1 firmware upgrade, 1 overview – Artesyn ATCA-7365 Installation and Use (May 2014) User Manual
Page 287: 2 installing the ipmitool, 1 update procedure, 10 firmware upgrade, 1 overview 10.1.2 installing the ipmitool, Chapter 10
Chapter 10
ATCA-7365 Installation and Use (6806800K65M)
287
Firmware Upgrade
10.1 HPM.1 Firmware Upgrade
10.1.1 Overview
The primary update mechanism for the ATCA-7365 blades is the FCU tool which is delivered
with the BBS package for the board. However, the ATCA-736X board family also supports
upgrade of the firmware with the HPM.1 specification. Upgradable components of the board
include the BIOS flash, FPGA flash, and IPMC flash. For update, it is recommended to use the
Pigeon Point System modified Ipmitool.
10.1.2 Installing the Ipmitool
procedure
1. Get the Pigeon Point System Ipmitool from the package (Ipmitool-1.8.9-pps-
7.tgz).
2. Extract the source code.
Prompt>tar -xzvf Ipmitool-1.8.9-pps-
3. Go to the directory where you have extracted the Ipmitool.
Prompt>cd
4. Build the Ipmitool.
Prompt>./configure && make && make install
10.1.2.1 Update Procedure
The Ipmitool HPM update requires two steps for an update:
1. Upgrade the component.
Example: ipmitool hpm upgrade
2. Activate the component.
Example: ipmitool hpm activate