Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 63)

Hardware Preparation and Installation
ATCA-7365 Installation and Use (6806800K65M) 63
Removal Procedure
To remove a PMEM/SATA module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 64 .
2. Remove the two screws holding the PMEM/SATA module .
3. Remove the PMEM/SATA module from the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 64 .
2.5.3 USB 2.0 Flash Module
The blades provides a USB 2.0 flash module with a capacity of 4 GB or 16 GB. The corresponding
removal/installation procedures are described in this section.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.