Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 78)

BIOS
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 78
 SMP 1.4
 ACPI 4.0
The BIOS setup program is required to configure the blade hardware. This configuration is
necessary for operating the blade and connected peripherals. The configuration data are
stored in the same flash device from which the board boots.
When you are not sure about configuration settings, restore the default values. This option is
provided in case a value has been changed and you wish to reset settings. To restore the default
values, press in Setup.
4.1.1 Update and Recovery
The ATCA-7370 has two different ways to update the BIOS.
 Flash tool (FCU and ipmitool in Linux). Used for normal upgrade mode.
 USB CD-ROM or USB flash device. This is used in BIOS recovery modes.
The BIOS contains online documentation which describes in detail the available menu
options. Therefore, the description in this manual is limited to the main BIOS functions.
 Loading the BIOS default values will affect all set-up items and will reset options
previously altered.
 If you set the default values, the displayed default values takes effect only after the BIOS
setup is saved and closed.