3 oem set/get acpi power commands, Table 8-26, Get serial output command – Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) User Manual
Page 204: Table 8-27, Ome set/get acpi power commands, Supported ipmi commands

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F)
204
The following table lists the request and response data applicable to the Get Serial Output
command.
8.3.3
OEM Set/Get ACPI Power Commands
This command can be used to change payload’s power state.
Table 8-26 Get Serial Output Command
Byte
Data Field
Request Data
1:3
Artesyn IANA Number (0065CDh). LSB first.
4
Serial connector type:
0 = Front panel connector
1 = Backplane connector
All other values are reserved.
5
Serial connector instance number. A value of 00h shall be used all other
values are reserved
Response Data
1
Completion code.
2:4
Artesyn IANA Number (0065CDh). LSB first.
5
Serial output selector.
0 = payload interface
All other values are reserved
Table 8-27 OME Set/Get ACPI Power Commands
Command name
NetFn
(Request/Response)
CMD
Description
OEM Set ACPI Power State
0x2E/0x2F
0x17
OEM Get ACPI Power State
0x2E/0x2F
0x18