Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 209)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 209
8.4 Pigeon Point Specific Commands
The IPMC supports additional IPMI commands that are specific to Pigeon Point. This section
provides detailed descriptions of those extensions:
Table 8-33 Pigeon Point Extension Commands
Command
NetFn
(Request/Response)
CMD
Get Status Table 8-35 on page 210 0x2E/0x2F 0x00
Get Serial Interface Properties Table 8-36 on page 213 0x2E/0x2F 0x01
Set Serial Interface Properties Table 8-37 on page 214 0x2E/0x2F 0x02
Get Debug Level Table 8-38 on page 215 0x2E/0x2F 0x03
Set Debug Level Table 8-39 on page 216 0x2E/0x2F 0x04
Get Hardware Address Table 8-40 on page 217 0x2E/0x2F 0x05
Set Hardware Address Table 8-41 on page 217 0x2E/0x2F 0x06
Get Handle Switch Table 8-42 on page 218 0x2E/0x2F 0x07
Set Handle Switch Table 8-43 on page 219 0x2E/0x2F 0x08
Get Payload Communication Time-Out Table 8-44 on page
219
0x2E/0x2F 0x09
Set Payload Communication Time-Out Table 8-45 on page
220
0x2E/0x2F 0x0A
Enable Payload Control Table 8-46 on page 221 0x2E/0x2F 0x0B
Disable Payload Control Table 8-47 on page 221 0x2E/0x2F 0x0C
Reset IPMC Table 8-48 on page 222 0x2E/0x2F 0x0D
Hang IPMC Table 8-49 on page 222 0x2E/0x2F 0x0E
Graceful Reset Table 8-50 on page 223 0x2E/0x2F 0x11
Get Payload Shutdown Time-Out Table 8-51 on page 224 0x2E/0x2F 0x15
Set Payload Shutdown Time-Out Table 8-52 on page 225 0x2E/0x2F 0x16
Get Module State Table 8-53 on page 225 0x2E/0x2F 0x27
Enable Module Site Table 8-54 on page 227 0x2E/0x2F 0x28
Disable Module Site Table 8-55 on page 227 0x2E/0x2F 0x29