Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 53)

Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 53
2.4 Installing the Blade Accessories
The following additional components are available for the blade:
 DIMM memory modules
 Cave Creek module
They are described in detail in the following sections. For order numbers refer to section
Ordering Information on page 43 .
2.4.1 DIMM Memory Modules
The blade provides eight memory slots for main memory DIMM modules. You may install
and/or remove DIMM memory modules in order to adapt the main memory size to your needs.
The corresponding installation/removal procedures are described in this section.
The location of the DIMM Memory Modules are shown in Figure "Blade Layout" on page 52 .
ATCA-7370/ATCA-7370-S supports low-voltage DDR3 memory. This is available upon
request.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten its life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.