beautypg.com

4 establishing a sol session – Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) User Manual

Page 181

background image

Serial Over LAN

ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F)

181

RMCP+ Cipher Suites : 1,2,3,3

Cipher Suite Priv Max : Not Available

root@localhost:~#

7.4

Establishing a SOL Session

To start a SOL session, the following requirements must be fulfilled:

An Ethernet LAN connection to the onboard Gigabit Ethernet controller of the ATCA-7370
must exist.

ATCA-7370 IPMC firmware must correspond to version 2.0.1 and above.

Procedure

To establish a SOL session, proceed as follows:

1. Make sure that the requirements detailed above are fulfilled.

2. Compile and install the ipmitool on your target which is destined for opening the

SOL session on the ATCA-7370. For details refer to

Installing the ipmitool

on page

177

.

3. Apply an IP address to the ATCA-7370 SOL interface. For details refer to

Configuring

SOL Parameters

on page 178

.

4. If necessary change user and password.

Default user is "soluser" and password is "solpasswd".

5. Configure the network between the ATCA-7370 and your target, which is destined

for opening the SOL session, so that the SOL IP address is accessible.

MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.

This manual is related to the following products: