Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 58)

Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 58
3. Remove the Cave Creek module from the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 58 .
2.5 Installing and Removing the Blade
The blade is fully compatible to the AdvancedTCA standard and is designed to be used in
AdvancedTCA shelves.
The blade can be installed in any AdvancedTCA node slot. Do not install it in an AdvancedTCA
hub slot.
2.5.1 Installing the Blade
To install the blade into an AdvancedTCA shelf, proceed as follows.
Damage of Circuits
Electrostatic discharge and incorrect blade installation and removal can damage circuits or
shorten its life.
Before touching the blade or electronic components, make sure that you are working in an
ESD-safe environment.
Blade Malfunctioning
Incorrect blade installation and removal can result in blade malfunctioning.
When plugging the blade in or removing it, do not press on the faceplate but use the
handles.