Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 155)

Maps and Registers
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 155
6.3.6 Serial Over LAN (SOL) Control Register
The IPMC software can route the serial data from serial port 1 (COM1) or serial port 2 (COM2)
to the IPMC.
6.3.7 Serial Routing Register
When both control bits are enabled, bit 1 is ignored.
Table 6-46 SOL Control Register
Address Offset: 0x04
Bit Description Default Access
0 SOL over COM1 enable:
0: disabled
1: enabled. COM1 is forwarded to IMPC 0 IPMC: r/w
LPC: r
1 SOL over COM2 enable:
0: disabled
1: enabled. COM2 is forwarded to IMPC 0 IPMC: r/w
LPC: r
7:2 Reserved 0 r
Table 6-47 Serial Routing Register
Address Offset: 0x05
Bit Description Default Access
1:0 00: COM1 to Faceplate and COM2 to RTM
01: COM1 to RTM and COM2 to Faceplate
10: BMC to Faceplate and COM2 to RTM
11: BMC to Faceplate and COM1 to RTM 00 IPMC: r/w
LPC: r