Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) User Manual
Page 56
Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F)
56
Note: On the single processor variant the second upper processor and its DIMM sockets are
not populated.
Cave Creek Module Installation
To install the Cave Creek module:
1. Remove the blade from the system as described in
Installing and Removing the Blade
.
2. Align and fasten the four M2.5x 8mm standoffs from bottom side of Cave Creek
module, using the four M2.5x 4mm screws.
3. Insert the Cave Creek module in the socket so that the module's standoffs fit in the
blade's mounting holes.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten its life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.