Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 144)

Maps and Registers
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 144
2 Parity Error (PE) indicator
When PE is set, it indicates that the parity of
the received data character does not match
the parity selected in the LCR (bit 4). PE is
cleared every time the CPU reads the
contents of the LSR. In the FIFO mode, this
error is associated with the particular
character in the FIFO to which it applies. This
error is revealed to the CPU when its
associated character is at the top of the FIFO:
1: Parity error occurred
0: No parity error 0 LPC: r
3 Framing Error (FE) indicator
When FE is set, it indicates that the received
character did not have a valid (set) stop bit.
FE is cleared every time the CPU reads the
contents of the LSR. In the FIFO mode, this
error is associated with the particular
character in the FIFO to which it applies. This
error is revealed to the CPU when its
associated character is at the top of the FIFO.
The ACE tries to resynchronize after a
framing error. To accomplish this, it is
assumed that the framing error is due to the
next start bit. The ACE samples this start bit
twice and then accepts the input data:
1: Framing error occurred
0: No framing error 0 LPC: r
Table 6-37 Line Status Register (LSR) (continued)
LPC IO Address: Base + 5
Bit Description Default Access