Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) - Manual (Page 54)

Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F) 54
Installation Procedure
To install a DIMM module, proceed as follows:
1. Remove blade from system as described in Installing and Removing the Blade on page 58 .
2. Open locks of memory module socket.
3. Press module carefully into socket.
As soon as the memory module has been fully inserted, the locks automatically close.
4. If applicable, repeat steps 2 to 3 to install further modules.
Removal Procedure
To remove a DIMM module, proceed as follows:
1. Remove blade from system as described in Installing and Removing the Blade on page 58 .
2. Open locks of socket at both sides.
The memory module is automatically lifted up.
3. Remove module from socket.
4. Repeat steps 2 to 3 in order to remove further memory modules.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten its life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.