1 set serial output command, 2 get serial output command, Table 8-25 – Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (June 2014) User Manual
Page 203: Set serial output command, Get serial output command, Supported ipmi commands

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54F)
203
8.3.2.1
Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port
connector. The following table lists the request and response data applicable to the Set Serial
Output command.
8.3.2.2
Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes
to a particular serial port connector.
Table 8-25 Set Serial Output Command
Byte
Data Field
Request Data
1:3
Artesyn IANA Number (0065CDh). LSB first.
4
Serial connector type:
0 = Front panel connector
1 = Backplane connector
All other values are reserved.
5
Serial connector instance number, a value of 00h shall be used all other
values are reserved
6
Serial output selector.
0 = payload interface
2 = IPMC debug console
All other values are reserved
Response Data
1
Completion code.
2:4
Artesyn IANA Number (0065CDh). LSB first.
Currently, only BIOS output is supported.