EVCO EPK4BHQ1AH Installer manual - Manual (Page 22)

EVCO S.p.A. c-pro 3 NODE kilo AHU | Application manual ver. 1.0
page 22 of 114
5 Parameter list
The parameters managed by the application are listed below. Each parameter is accompanied by a brief description,
the range of its admissible values, units of measure, the assigned default value and the menu containing the
parameter. Menus are structured on the basis of the following logic:
OR: Clock menu
UT: User menu
TB: Time Bands
MA: Maintenance menu
MA-F: Maintenance menu – operating branch
MA-M: Maintenance menu – manual branch
MA-CA: Maintenance menu – calibration branch
IS: Installation menu
IS-R: Installation menu - control branch
IS-F: Installation menu - fans branch
IS-B: Installation menu – heating-cooling coils branch
IS-U: Installation menu - humidifier branch
IS-SE: Installation menu - damper branch
IS-RH: Installation menu – heat exchanger branch
IS-P: Installation menu - pump branch
IS-S: Protection device - branch installation menu
IS-M: Installation menu - modbus branch
IS-Et: Installation menu - ethernet branch
IS-V: Installation menu - various parameter branch
IS-D: Installation menu - default branch
IS-C: Configuration parameters branch - installer menu
IS-AI: Hardware AI parameters - installer menu
IS-DI: Hardware DI parameters - installer menu
IS-AO: Hardware AO parameters - installer menu
IS-DO: Hardware DO parameters - installer menu