EVCO EPK4BHQ1AH Installer manual - Manual (Page 20)

EVCO S.p.A. c-pro 3 NODE kilo AHU | Application manual ver. 1.0
page 20 of 114
In the CONTROL Menu you can set/view parameters for various specific controls:
- compensation control set point
- sniffing cycles for air room temperature acquisition
Within the FANS, HEATING-COOLING COILS, HUMIDIFIER, DAMPERS HEAT RECOVERY DEVICE and PUMPS menus you
may set the related parameters to manage the devices:
- control parameters
- timing
- operation
The PROTECTION DEVICE menu contains all parameters connected with alarms and management of safety devices
which protect the refrigerating circuit:
- activations
- reporting delays
- type of reset
- alarms signal
The MODBUS menu contains all parameters for configuration of the network.
The ETHERNET menu contains all parameters for configuration of the Ethernet network (IP, Gateway, Subnet Mask).
The VARIOUS menu contains other general parameters:
- Set maximum threshold values
- Set Modbus communication
- Enable secondary Set Point of change-over and supervisor
- Enable summer/winter modes from Digital inputs and supervisor
- Enable sensors
- Set logic for digital input/output
- Reset history
- Set unit of measurement
- Set sensor type: return temperature, flow, external, humidity, channel pressure, air quality, flow humidity,
potentiometer, input logic, coil 1, coil 2, fan, damper, humidifier, heating elements, recovery device
From the DEFAULT PARAMETER menu it is possible to restore the default values of all parameters of the application
and save or download from the USB pen drive.
This menu is only accessible when the device is off.
The CONFIGURATION PARAMETERS Menu allows you to set/view the parameters relating to the characteristics of the
machine.
- Unit type
- Number of coils
- Enable devices
In the HARDWARE AI there are parameters relative to the use of the AI.
In the HARDWARE DI there are parameters relative to the use of the DI.
In the HARDWARE AO there are parameters relative to the use of the AO.
In the HARDWARE DO there are parameters relative to the use of the DO.