ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 33)

1-26 ADS TRITON+ Manual
Installation and Configuration
Following is the general procedure for installing and configuring a
TRITON+ monitor. Refer to Chapters 3 through 6 for more
details.
 Investigate Site Characteristics
• Flow Hydraulics
• Pipe and Manhole Characteristics
 Prepare Monitor and Sensors for Installation
• Assemble Ring (when applicable)
• Mount Sensors to Ring or Special Bands
• Secure Sensor Cables to Ring or Special Bands
 Install Sensors in the Pipe
• Install Ring or Band in Pipe
• Secure Sensor Cables Along Pipe and Up Manhole
 Install Monitor in Manhole
• Connect Sensors to Monitor
 Establish Wireless or On-Site Communication with
Monitor
Note: This manual provides instructions on performing
the remaining activities through the ADS Qstart
™
software.
 Configure Monitor (Qstart software)
• Create Monitor Location
• Create Installation Table
• Select and Edit Devices
 Set Communication Parameters (Qstart software)