ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 326)

Maintenance and Troubleshooting 10-5
LED STATUS window on monitor top
Viewing Monitor Activity Codes
Monitor activities, such as reading sensors or transmitting/receiving
messages, display on the LED automatically in the form of
individual characters. Each character represents a specific activity.
Appendix C provides a list of these characters and the activities to
which they correspond. The presence of a yellow light at the upper
left portion of the display indicates the monitor is awake or involved
in active communication.
Activating and Reading the Diagnostic Codes
The diagnostic information available through the LED corresponds
to power and wireless communication, such as signal strength,
battery voltage, and IP address. These codes are particularly useful
during site investigation and system installation to ensure an
adequate and consistent signal strength, test communications, and
verify the monitor IP address.
Accessing and activating the diagnostic codes require you to prompt
the monitor with a small magnet (ADS p/n 8000-0140). Activate
the diagnostic code sequence by holding the magnet against the red
dot (labeled WAKE) located above the LED window on the