ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 10)

Introduction 1-3
The TRITON+ has also been certified for use in Zone 0 via testing
to ATEX (Atmosphere Explosibles) standards. It is certified to
ATEX standards in Europe and for use in all classified (hazardous)
sanitary sewer and industrial hazardous areas. Many rest-of-world
countries accept ATEX certification in lieu of their country-specific
requirements.
The TRITON+ flow monitor has been tested to CSA (Canadian
Standards Association) standards and certified for use in Canada in
Intrinsically Safe and Non-Incendive Systems – For Hazardous
Locations. The CSA certification allows demonstrated compliance
for use in Ex ia IIB T3 (152 C) areas in Canada.
It is the customer’s responsibility to ensure that the certification(s)
provided for the ADS equipment meets the applicable regulatory
requirements.
Note: TRITON+ models include the 8000-FST-IM and
8000-FST-IM-EP.
TRITON+ System Certification
The TRITON+ unit and associated telemetry equipment are
certified for use only with approved ADS battery packs, sensors,
communication cables, and telemetry equipment. Connection of
any non-approved devices could result in unsafe operation and will
immediately void the warranty and IS certification.
Note: Connecting the Telog ® Ru-33 to the ADS
TRITON+ is an approved application and, therefore, will
not void the TRITON+ warranty. However, because the
Telog unit is not IS certified, the installation will not be
considered intrinsically safe if the Ru-33 is installed in the
manhole with the monitor.