ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 250)

Configuration and Activation 6-63
Note: Be sure to choose the Connect type of FTP when
performing wireless data collects, monitor activations, or
firmware updates for monitors equipped with SIMs with
dynamic IP addresses and using the FTP Operations
device.
Use the following information to successfully configure the FTP
Operations device:
 Address Enter the IP address (or URL) for the FTP site to be
used for the FTP Operations activities.
 Folder Enter the name of the root folder to be used on the
FTP site. During monitor activation, Qstart creates this folder
(if not already there) and a sub-folder (based on the location A
location refers to a specific flow monitor or rain gauge included
in a flow monitoring network. name). The monitor stores
uploaded data files and Qstart stores uploaded monitor
activation and firmware update request files to the location sub-
folder. For maintenance purposes, Qstart deletes data files
from the FTP site after a data collect and the monitor deletes
activation and firmware update files after performing the
requested activity.
 Username Enter the username through which to access the
FTP site.
 Password Enter the password through which to access the
FTP site.
 Interval Choose the frequency (in hours) which the monitor
should use to upload CSV data files to the FTP site and to
check the FTP site for monitor activation and firmware update
requests.