ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 200)

Configuration and Activation 6-13
Note: Do not assign two devices of the same type to the
same monitoring point. When data collection occurs,
Qstart will overwrite the collected data from the first
device with the data from the second device of the same
type. This also will occur when collecting data using other
ADS software products. Therefore, assign only one of the
two devices (of the same type) to a single monitoring
point.
Note: The Smart Depth device represents the standard
Ultrasonic Depth Sensor on the Available Devices dialog.
However, the Ultrasonic Depth Sensor with the pressure
option is represented by the Surface Combo device in
Qstart. Therefore, make sure you select the proper device
when assigning the Ultrasonic Depth Sensor to a
monitoring point.
3. Click on the OK button.
4. Select a device in the Devices box, and click on the View
button.
The device dialog displays the default or existing parameters
for the selected device.
5. Edit the parameters for the selected device as necessary, and
then click OK on the device dialog when complete.
6. Repeat steps 4 and 5 for each additional device in the Devices
box and then click Save to store the changes to your local
directory or network. Refer to the following pages for more
information on editing devices:
Device: See Page:
Peak Combo 6-15
Surface Combo 6-28
Smart Depth 6-44
Modem Setup 6-49