Metrohm 711 Liquino - Manual (Page 65)

3 Introduction
711 Liquino, Instructions for use 59
2x Di spl ay: >GLP opt i ons bal ance- I d • Enter an unambiguous identification for the balance used (e.g. serial number). The input of text is explained on 63. Di spl ay: par amet er s >GLP r epor t s • As the ‘GLP options’ submenu contains no further menu items, an automatic return is made to the submenu selection. Press
to open the submenu ‘GLP reports’. The reports which are to be print-
ed out automatically at the end of the GLP test are defined here. Di spl ay: >GLP r epor t s no. 1 r epor t : of f • The key can be used to select from the following reports:
2x
Di spl ay: >GLP opt i ons
bal ance- I d
• Enter an unambiguous identification for the balance used (e.g. serial
number). The input of text is explained on 63.
Di spl ay: par amet er s
>GLP r epor t s
• As the ‘GLP options’ submenu contains no further menu items, an
automatic return is made to the submenu selection. Press
to open the submenu ‘GLP reports’. The reports which are to be print-
ed out automatically at the end of the GLP test are defined here.
Di spl ay: >GLP r epor t s no. 1
r epor t : of f
• The
• ‘off’: no report
• ‘result’: summary of the results
• ‘parameter’: parameter settings
• ‘curve’: graph of the measurement
• ‘detail’: results in detail with list of measuring points
• ‘ff’: page feed (may be useful between 2 reports)
Select the reports to be printed out and press the key after
each selection. Up to 5 entries can be made.
Press 2x to exit the parameter menu.
All the necessary parameters have now been entered!
Various GLP methods can be edited and stored in the method memory.
Each of these memories can then be reloaded by pressing a few keys.
The method memory is described on page 128.