Metrohm 711 Liquino - Manual (Page 54)

3.2 Tutorial
711 Liquino, Instructions for use 48
2x <> dos. uni t : st andar d • In this menu item the 711 Liquino is informed about the tubing of the Dosino. Press until the dosing unit defined in the above
preparation step appears. Confirm with .
2x <>
dos. uni t : st andar d
• In this menu item the 711 Liquino is informed about the tubing of the
Dosino. Press
• Skip the next menu item with .
Di spl ay: par amet er s
>XDOS moni t or i ng
• As the submenu ‘>XDOS dosing units' does not contain any further
menu items, an automatic return is made to the submenu selection.
Press to open the submenu ‘>XDOS monitoring'.
Di spl ay: >XDOS moni t or i ng
t emper at ur e: of f
• Use the key to select the entry ‘on’. This activates the temperature monitoring. Di spl ay: >XDOS moni t or i ng l ow l i mi t - 70 ° C • The lower temperature limit is of no interest in this application. Accept the default value with . Di spl ay: >XDOS moni t or i ng upper l i mi t 200 ° C • Set the upper temperature limit to 10 °C. Confirm the entry with . Di spl ay: >XDOS moni t or i ng act i on: none • The action to be taken if the temperature exceeds the set limits is de-termined here. Use to choose the entry ‘wait’. This stops
any addition when the temperature is outside the limits. When the tem-
perature again lies within the limits the addition will be continued. Ac-
cept the setting with .
temperature monitoring.
Di spl ay: >XDOS moni t or i ng
l ow l i mi t - 70 ° C
• The lower temperature limit is of no interest in this application. Accept
the default value with .
Di spl ay: >XDOS moni t or i ng
upper l i mi t 200 ° C
• Set the upper temperature limit to 10 °C. Confirm the entry with
.
Di spl ay: >XDOS moni t or i ng
act i on: none
• The action to be taken if the temperature exceeds the set limits is de-
termined here. Use
• No further entries are necessary in the ‘XDOS monitoring’ submenu.
Exit with the key.
Di spl ay: par amet er s
XDOS moni t or i ng
• Press <> 2x to switch to the submenu ‘XDOS reports’. *)
Di spl ay: par amet er s
>XDOS r epor t s
• Press to open the submenu.
Di spl ay: >XDOS r epor t s
t emp. aut o scal e: on
*) If no printer or PC is connected the parameter menu can be exited with and the method rejoined
at "Running the method“.